RCA RCRVD2022 - Manual (Page 25)

Troubleshooting
Most problems you encounter with your TV/DVD can be corrected by consulting the following
troubleshooting list.
TV Problems
TV won’t turn on
• Press the POWER button.
• Make sure the TV is plugged in.
• Check the wall receptacle (or extension cord) to make sure it is “live” by plugging in something else.
• Something might be wrong with your remote control. Press the POWER button on the front of the TV. If
the TV turns on, check the remote control solutions on page 24.
Buttons don’t work
• If you’re using the remote control, press the TV button fi rst to make sure the remote is in TV mode.
• Unplug the TV for two minutes and then plug it back in. Turn the TV on and try again.
TV turns off unexpectedly
• Sleep timer might have been activated.
• Electronic protection circuit may have been activated because of a power surge. Wait 30 seconds and
then turn on again. If this happens frequently, the voltage in your house may be abnormally high or low.
• Unplug TV. Wait fi ve minutes. Plug it in again.
Blank screen
• Try another channel.
No sound, picture okay
• Maybe the sound is muted. Try pressing the volume up button to restore sound.
Can’t select certain channel
• Channel may be blocked or not approved through the v-chip (Parental Control).
Noisy stereo reception
• May be a weak station. Access the SOUND menu (see page 8), highlight MODE and then choose MONO.
No picture, no sound but TV is on
• Maybe the signal type (SOURCE) is set wrong. Go to page 9 for detailed instructions.
• The channel might be blank — change channels.
• If in DVD mode, press TV, then the INPUT button twice for the CABLE or AIR channels.
Sound okay, picture poor
• Check antenna connections. Make sure all of the cables are fi rmly connected to the jacks.
• Try adjusting sharpness function to improve weak signals.
Black box appears on the screen
• Closed caption might be on.
20F510TDr.indd 23 20F510TDr.indd 23 7/28/05 2:06:58 PM 7/28/05 2:06:58 PM
Other Information
Other Information 23
NOTE: When in DVD mode, to switch back to TV mode, please press the "TV" button
on the remote control,then press on the "INPUT" button and select TV.