Remington 493 - Manual (Page 3)

3 103500
Warning: Safety Precautions
IMPORTANT: Read these operating instructions carefully and com-
pletely before trying to operate or service this tool. Improper use of
this tool can cause serious injury or death from firing fastener into
body or from flying debris. We expressly disclaim any liability for any
injury to persons or damage to property which result from your failure
to take the precautions contained in this manual.
WARNING: This tool is designed only for use by qualified operators.
Qualification is obtained through a thorough understanding of the Safety
Warnings and operating instructions as defined in this operating manual.
NOTE: Your local labor regulations may require that the operator of this tool
on a job site be thoroughly trained and certified for competence prior to
operating this tool. For certification procedures, call: 1-800-626-2237
(U.S.A.) or 1-905-826-8010 (Canada).
1. Always handle the tool as if it were loaded. Before starting work, check that the
tool is unloaded and the muzzle is clear. Never load a tool unless it is going to
be used.
2. Always inspect to make sure the tool is working properly. If the tool does not
work properly, remove from service and tag “DEFECTIVE.” Do not use the tool
again until it has been properly repaired.
? ?
DEFECTIVE
BEFORE USING
3. Operators and bystanders must wear goggles and ear protection which meet
or exceed the accepted standards for adequate protection in your country. In
the U.S.A., refer to ANSI standards. In Canada, refer to CSA standards.