Assembly, Table extension, Mounting the miter saw to the leg stand – RIDGID MS1250LZ User Manual
Page 16
16
17
ASSEMBLY
Fig. 12
Fig. 10
LEG STAND ASSEMBLED
TABLE EXTENSION
See Figure 11.
The table extension can be used on the left side of the miter
saw. To assemble and install the table extension:
n
Insert socket head screw and washer into the two holes
in the side of the miter saw base.
n
Tighten securely.
MOUNTING THE MITER SAW TO THE LEG
STAND
See Figure 12.
n
Turn leg stand upright as shown in figure 10.
n
Carefully place miter saw on top of leg stand. Align holes
in the miter saw base with holes in leg stand.
n
Insert the 5/16-18 x 2-1/2 in. hex bolts in each of the four
holes and secure using hex nuts.
n
Tighten all hardware with a wrench. You may find it helpful
to use one wrench to hold the head of the bolt and one
to tighten the hex nut.
UPPER SIDE
BRACE (C)
UPPER
BRACE (A)
LOWER SIDE
BRACE (D)
LOWER
BRACE (E)
LEG (B)
15
20
25
30
35
40
45
10
�
HEX
NUT
HEX
BOLT
Fig. 11
15
20
25
30
35
40
45
10
TABLE
EXTENSION
SOCKET HEAD
SCREW
WASHER
WASHER