Roberts Radio CRD-36 - Manual (Page 7)

If.you.need.any.further.advice,.please.call.our.Technical.Helpline.on.:-
020.8758.0338.(Mon-Fri)
6
Using the clock radio for the first time
Your clock radio is supplied with a Mains Adaptor.
1. Place your clock radio on a flat surface.
2. Insert the adaptor plug into the DC socket located on the rear of your
clock radio.
. IMPORTANT: The mains adaptor is used as the means of
connecting the clock radio to the mains supply. The mains socket
used for the clock radio must remain accessible during normal use.
In order to disconnect the clock radio from the mains completely,
the mains adaptor should be removed from the mains socket outlet
completely.
3. Fully extend the wire aerial located on the rear of your clock radio. The
wire should be fully extended and positioned for optimum reception.
4. Plug the adaptor into a standard 13 amp mains socket outlet.
5. When your clock radio is first switched on the display will show "Setting
Clock" and a station search will be performed automatically.
6. When stations have been found, the clock information will appear on
the display. Press the Display button to toggle between showing the
time only or showing both the date and time.
7. If no stations have been found "Clock not set" will be displayed. It may
then be necessary to relocate your clock radio to a position giving bet-
ter reception. You should then carry out an autoscan to find stations
as described on page 10.