RocketFish RF-GPS3101 - Manual

Charging the battery
Before you use the controller for the fi rst time, or after you have
not used it for a long time, you must charge the battery. (If the
controller will not be used for long periods of time, the battery
should be recharged at least once every six months.) It takes
approximately 3.5 hours to fully charge the battery.
To charge the battery
1 Insert the mini-USB plug on the charging cable into the USB
port on the front of the controller.
IMPORTANT: Make sure that the min-USB plug is aligned correctly with
the port before inserting into the plug to avoid damaging either the port
or the plug.
NOTE: Recharging a battery that has not been fully
discharged shortens its life.
2 Insert the USB plug into the USB port on your PS3,
which must be plugged in and drawing power.
3 Turn on your PS3. The battery starts charging
and the PS button in the middle of
the controller lights blue. When the
battery is fully charged, the PS light
turns off .
QUICK SETUP GUIDE
Congratulations on your purchase of a new Rocketfi sh Rapid Fire
Wireless Controller. This controller was designed with input from
gamers and includes some exciting new features:
• A modifi ed design: better stick placement; a responsive,
one-piece directional pad; improved handle ergonomics, and
one-button Rapid Fire
• TouchSense®, dual rumble motors for lifelike vibration
• Wireless connectivity to your PS3™ console
• Power up your PS3™ console directly from the controller
• A built-in, rechargeable NiMH battery
Package contents
• Wireless controller with a built-in, rechargeable battery
• 9 ft. (2.74 m) USB charging cable
Rapid Fire Wireless Controller
RF-GPS3101
Product features
Top
# Description
1 PS button
2 Select button
3 Left stick
4 Rapid Fire button
5 Directional pad
6 Start button
Back
# Description
1 USB port
2 R1 button
3 R2 button
# Description
4 Port indicators
5 L1 button
6 L2 button
Pairing your controller
Before you use your controller, you need to pair it with your PS3
console.
1 Connect the USB cable between your controller and PS3
console.
2 Turn on the controller, then press its PS button. When the PS3
recognizes your controller, all the port indicators fl ash slowly.
PS
2 1 4 3
2 1 4 3
3 Press the PS button again to assign a port number.
Notes:
• Pairing and assigning controller numbers can only be done when the
system is turned on.
• When a paired controller is used with another PS3 system, the pairing
with the original system is cleared. Pair the controller with the system
again if the controller has been used with another system.
• If the controller or the system is turned off , the port indicators on the
controller turn off and the assigned number is cleared.
# Description
7 button
8 button
9 button
10 button
11 Right stick/R3 button
12 Power switch
When your controller has been
assigned to a port, the indicator
number for the port turns solid red.
PS
PS