RedMax POWER AUGER AG4300 - Manual (Page 16)

16 
5. Storage
■ Before Long-term Storage
• Drain fuel tank and run engine out until all
fuel in the carburetor is used up.
• Remove the spark plug and drop a
spoonful 2 cycle oil into the cylinder.
Crank the engine several times and
replace the plug.
Pull starter until compression is felt.
• Brush off dirt from the drill surface and
apply rust protective oil.
• Store the machine in a dry, dust-free
place.
Model Name ...................................................................................................................AG4300
Engine
Displacement cu.in(cc) ........................................................................................2.53 (41.5)
Maximum power kW(HP) ....................................................................1.5 (2.0) at 7000 rpm
Carburetor ...........................................................................Diaphragm type (Walbro WYK)
ignition system ...............................................................................................Electric (T.C.I)
Spark plug .....................................................................................................NGK BPMR7A
Starter .............................................................................................................Recoil starter
Fuel .............................................................................2 cycle oil premixed gasoline (50:1 )
(when using ZENOAH genuine oil)
Fuel tank capacity fl.oz(lit) .............................................................................................32 (0.94)
Transmission .................................................................Centrifugal clutch, worm gear reduction
Gear box lubricant .......................................................................................Gear oil SAE#80-90
Reduction ratio .....................................................................................................................45:1
Grip span in (mm) .......................................................................................................21.2 (540)
Over all dimensions
Length in (mm) .....................................................................................................24.8 (630)
Width in (mm) .......................................................................................................14.4 (359)
Height w/o drill in (mm) ........................................................................................11.7 (292)
Dry weight w/o drill Ids (kg) ..........................................................................................19.3 (8.9)
Adaptable drill size
Diameter in (mm) ...................................................................................0.8 to 8 (20 to 200)
Specifications are subject to change without notice.
6. Specifications