Operation – RedMax POWER AUGER AG4300 User Manual

Page 12

3. Operation

aspect while holding the throttle lever, and set
the throttle lever in the start position. (F6)

(1) Engine switch
(2) Start
(3) Stop
(4) Choke lever
(5) Open
(6) Close
(7) Primer pump
(8) Throttle lever
(9) Lock button

6. While supporting the auger with your left waist

and left hand as shown in the figure, pull the
starter rope, first lightly and add force when
compression is felt. (F7)

Keep the drill clear of everything around it as it
will start rotating upon starting of engine.

7. When the engine has started, gradually open the

choke and release the throttle lever.

8. Alow the engine to warm up for a half minutes

before starting operation.

• When re-starting immediately after stopping the

engine, keep the choke open.

• If the engine won’t start after repeated attempts,

it may be overfed with fuel. Remove and dry the
spark plug, and try to start again with the choke
open.

■ STOPPING ENGINE
1. Release the throttle lever to allow the engine

idling for a few minutes

2. Put the switch to the “STOP” position. (F8)

(1) Engine switch

■ DRILLING (F9)

• Keep a firm grip of the auger at all times on a

wide stance and by holding the handle with both

NOTE

WARNING

12 