Raymarine Wind & Close Hauled Wind Instrument ST60 - Manual (Page 27)

Chapter 3: Installation 15
Each ST60 instrument is supplied with a standard bezel for surface mounting.
Optional mounting kits are available for flush mounting and bracket mounting
the instrument. If you have ordered the flush mounting option a low-profile bezel
and four fixing screws are also provided.
Fitting the instruments
The ST60 Wind and ST60 Close Hauled Wind instruments can be installed using
one of a number of different mounting options:
• Surface mounting. Gives a profile of approximately 0.95 in (24 mm).
• Flush mounting. Gives a profile of approximately 0.25 in (6 mm).
• Bracket mounting.
The ST60 instruments can also be mounted behind a panel with just the
instrument dial and keys visible.
Surface mounting
To surface mount your ST60 instrument (see the Surface mounting illustration):
1. Ensure that:
• The selected location is clean, smooth and flat.
• There is sufficient space behind the location to accommodate the rear of
the instrument and connectors.
Surface mounting
D4306-2
1 1 2 2 3 4 5 5