Panasonic SL SX 330 - Manual (Page 8)

8
8
RQT7180
Troubleshooting guide
References to the remote control apply only to SL-SX332.
No play.
No sound or there is a
lot of noise.
Play doesn’t resume from
the track where play
stopped at.
Play doesn’t start from
the first track.
Cannot specify the AB
segment.
The unit malfunctions
when connected to other
equipment.
Cannot hear the remote
control’s operation tone.
The remote control does
not work properly.
Cannot recharge.
SL-SX332
The AC adaptor
becomes warm during
recharging.
The batteries are taking
a long time to recharge.
Play time is short after
recharging.
The battery indicator fails
to appear or is incorrect.
The unit stops working.
(
)
*
'
Display
Before requesting service, make the below checks. If you are in doubt about some of the check points, or if the remedies indicated in the chart do not solve the problem,
consult your dealer for instructions.
≥The HOLD function is on. Release HOLD ( ➪page 5).
≥The batteries may have run empty ( ➪page 4).
(If play is extremely short even after fully recharging the
batteries, the batteries may have exceeded their life.
Rechargeable batteries can be recharged approximately
300 times.)
≥The disc isn’t correctly set.
≥The disc is scratched or dirty. (Tracks skipped.)
≥There is moisture on the lens. Wait for about an hour and
then try again.
≥The lens is dirty: clean it with a blower (recommended
product: SZZP1038C).If the lens gets marked with
fingerprints, gently wipe them off with a cotton swab.
≥Ensure the plugs are inserted firmly.
≥Wipe the plugs clean with a clean cloth.
≥The elapsed playing time disappears and sound is interrupted
if bumps continue repeatedly.
≥This doesn’t work if you open the lid while the unit is in stop
mode.
≥This doesn’t work during random play.
≥It may not work correctly under some conditions.
≥Random play modes may be on ( ➪page 6).
≥Play resumes from the track where you last stopped play
(play may start from a different track if you change discs after
the power has been turned off).
You may not be able to specify segment A or B at the end of
disc.
Be sure to connect other equipment through the remote
control. Speakers connected directly to the unit should have an
impedance of 1 k≠ or less.
The operation tone may be off ( ➪page 6).
Use only the included remote control to operate this unit.
≥You aren’t using the special rechargeable batteries (
➪page 4).
≥You must insert two batteries before you can recharge them.
≥The unit must be off before you can recharge.
This is normal.
The batteries may take a maximum of 6 hours to recharge
under some conditions.
≥This may occur after the first time you recharge the batteries
or haven’t used them for a long time. Play time should be
restored after a few recharges.
≥The batteries can go flat if you leave the AC adaptor
connected after recharging is complete.
≥The indicator does not appear when the AC adaptor is
connected.
≥The indicator does not appear correctly under some
conditions.
Disconnect then reconnect all power sources (batteries and AC
adaptor).
The HOLD function is on. Release HOLD ( ➪page 5).
≥You haven’t inserted a disc or it isn’t inserted correctly.
≥You have inserted a disc this unit cannot play.
The disc lid is open.
The program already contains 20 tracks.