Radio Shack 15-1915B - Manual (Page 7)

Need help? Call 1-800-950-7557
7
SETTING UP YOUR DEVICE
CODES
1. Refer to “Manufacturers’ Codes” on Page 11
and write down the codes for your original
remote controls on the provided label.
2. Press the device key for the type of remote
you are replacing ( TV , VCR , or CBL ). The red
light blinks.
3. Hold down P until the red light blinks twice,
then enter your 4-digit code.
For example, to replace a Panasonic TV’s
remote control (manufacturer code 1433),
press
TV , hold P for two blinks, release, then
enter the 4-digit code.
VOL s CHAN t CHAN s CHAN s
The red light blinks twice.
4. Point the Pocket Remote at your device and
press PWR . The device should turn on (or off,
if it was on).
Repeat Steps 2–4 for additional devices.
Notes:
• The red light at the top of the Pocket Remote
blinks twice when you enter a code that it
recognizes. (This does not mean that it is the
right code for your device.)
Press For Number
VOLs 1
VOLt 2
CHANs 3
CHANt 4
15-1915b.fm Page 7 Monday, July 19, 1999 12:06 PM