Radio Shack TAD-727 - Manual (Page 28)

28
REMOTE OPERATION
USING THE TOLL-SAVER
When you call the TAD-727 and the
number of rings to answer calls is set to
“toll-saver”, it answers after about two
rings if you have new messages (ones
you have not listened to). If there are no
new messages, the TAD waits for about
five rings before it answers. This gives
you time to hang up before the TAD an-
swers so you can avoid long-distance
charges.
SETTING THE REMOTE
OPERATION PIN
The remote operation PIN (personal
identification number) permits remote
access to the TAD. The PIN can be any
number from 00 to 99. The default set-
ting is 99, but you can change it by fol-
lowing these steps.
1. Press REMOTE on the handset so
the TALK/LOW BATT indicator
lights. The TAD announces the
number of messages you have (if
any).
2. Press PIN/# on the handset. Then
the TAD announces the current PIN
through the handset.
3. Enter your two-digit PIN.
4. Press PIN/# on the keypad again.
Then the TAD announces your new
PIN stored through the handset’s
speaker.
5. Press REMOTE so the TALK/LOW
BATT indicator turns off.
Accessing the TAD Remotely
While you are away from your home,
you can use a touch-tone phone, or a
pulse (rotary) phone with a pocket tone
dialer, to enter your PIN and do any of
the following:
• set the TAD to answer calls
• select an outgoing message
• listen to your messages
• record a new announcement
• record a memo
• delete messages
• turn the TAD off
Note: You cannot access the TAD from
another telephone on the same line as
your TAD-727.
1. Dial your phone number and wait for
the TAD to answer.
The TAD automatically turns itself
on to answer your call.
2. When the outgoing message ends,
press then enter your 2-digit PIN
within 2 seconds.
PIN/#
43-727.fm Page 28 Monday, December 20, 1999 4:28 PM