beautypg.com

Troubleshooting, Specifications, Power indicator is not lit – ROTEL RCD-06 User Manual

Page 9: Fuse replacement, No sound, English

background image

9

Troubleshooting

Most difficulties in audio systems are the result

of incorrect connections, or improper control

settings. If you encounter problems, isolate the

area of the difficulty, check the control settings,

determine the cause of the fault and make the

necessary changes. If you are unable to get

sound from the RCD-06, refer to the sugges-

tions for the following conditions:

Power Indicator Is Not Lit

The Power Indicator and the basic items in the

Display window should be lit whenever the

RCD-06 is plugged into the wall power outlet

and the Power button is pushed in. If it does

not light, test the power outlet with another

electrical device, such as a lamp. Be sure the

power outlet being used is not controlled by

a switch that has been turned off.

Fuse Replacement

If another electrical device works when plugged

into the power outlet, but the Power Indica-

tor and the Display still will not light when

the RCD-06 is plugged into the wall outlet,

it indicates that the internal power fuse may

have blown. If you believe this has happened,

contact your authorized Rotel dealer to get the

fuse replaced.

No Sound

Check the cables between the RCD-06 and the

amplifier inputs to be sure they are connected

properly. Be sure the correct amplifier input is

selected. Be sure the tape monitor system of

the amplifier has not been activated. Check

the wiring between the amplifer and the

speakers.

Specifications

Total Harmonic Distortion + Noise

0.0045% @ 1kHz

Intermodulation Distortion

0.0045% @ 1kHz

Frequency Response (± 0.5 dB)

20-20,000 Hz

Channel Balance

± 0.5 dB

Phase Linearity

± 0.5 degree

Channel Separation

> 98 dB @ 1kHz

Signal to Noise Ratio

> 100dB

Dynamic Range

> 96 dB

Digital to Analog Converters

Enhanced, multi-level Delta-Sigma DAC

8x oversampling digital filter

Speed Accuracy, Wow & Flutter

Quartz Crystal Precision

Output Impedance

100 Ohms

Digital Output

0.5 Volt, Peak to Peak

Load Impedance

75 Ohms

Power Requirements

USA Version

AC 120V, 60 Hz

European Version

AC 230V, 50 Hz

Power Consumption

20 Watts

Dimensions (W, H, D)

171/8 x 27/8 x 125/16 inches

437 x 73 x 313 mm

Panel Height

60 mm / 23/8”

Weight (net)

5 kg, 11 lb.

All specifications are accurate at the time of printing.
Rotel reserves the right to make improvements without notice.

Rotel and the Rotel HiFi logo are registered trademarks of The Rotel Co, Ltd., Tokyo, Japan.

English