Raypak Gas Fired Boiler - Manual (Page 5)

technician to inspect the appliance and to
replace any part of the control system and any
gas control which has been under water.
LIGHTING INSTRUCTIONS
1. STOP! Read the safety information above.
2. Set the thermostat on the lowest setting.
3. Turn off all electric power to the appliance.
4. This appliance is equipped with an ignition
device which automatically lights the pilot. Do
not try to light the pilot by hand.
5. Remove boiler door panel.
6. Turn gas control knob clockwise to
“OFF”. Make sure knob rest against stop.
7. Wait five (5) minutes to clear out any gas. Then
smell for gas, including near the floor. If you smell
gas, STOP! Follow "B" in the safety information
above on this label. If you don't smell gas, go to the
next step.
8. Turn gas control knob counter clockwise
to “OFF” until it stops. Push in gas control knob
and continue rotating counter clockwise
to “ON” position. Make sure knob rest against
stop.
GAS CONTROL
KNOB SHOWN
IN "ON"
POSITION
GAS INLET
9. Replace boiler door panel.
10. Turn on all electric power to the appliance.
11. Set thermostat to desired setting.
12. If the appliance will not operate, follow the
instructions “TO Turn Off Gas To Appliance”
and call your service technician or gas supplier.
TO TURN OFF GAS TO APPLIANCE
1. Set the thermostat to the lowest setting.
2. Turn off all the electric power to the appliance if
service is to be performed.
3. Remove boiler door panel.
4. Turn gas control knob clockwise to
"OFF". Make sure knob rest against stop.
5. Replace boiler door panel.
BOILERS WITH AUTOMATICALLY LIT IID
PILOTS AND AUTOMATIC GAS VALVES
Lighting Instructions
1.
Close all gas valves. Turn off electric power
supply. Wait 5 minutes.
2. Open manual pilot valve. Turn on electric
power. Pilot is automatically lighted.
3. Open main gas valve.
4. Set temperature controls to desired tempera-
ture.
To Shut Down
Close all manual gas valve. Turn off electric
power.
Fig. # 8929.1
IGNITION MODULE
BOILERS WITH AUTOMATICALLY LIT C2/IRI
PILOT AND MANUAL GAS VALVES
FOR YOUR SAFETY READ BEFORE OPERATING
WARNING: If you do not follow these instructions
exactly, a fire or explosion may result causing property
damage, personal injury or loss of life.
A. This appliance is equipped with an ignition device
which automatically lights the pilot. Do not try to
light the pilot by hand.
B. BEFORE OPERATING Smell all around the appli-
ance area for gas. Be sure to smell next to the floor
because some gas is heavier than air and will settle
on the floor.
WHAT TO DO IF YOU SMELL GAS
* Do not try to light any appliance.
* Do not touch any electric switch:
do not use any phone in your building.
* Immediately call your gas supplier from a neigh-
bor's phone, follow the gas supplier's instruc-
tions.
* If you cannot reach your gas supplier, call the
fire department.
5
Fig.# 8082