RCA DIRECTV PLUS 15407690 - Manual (Page 36)

Final Installation
34 Chapter 3
4 If you have not already mounted the multiswitch inside your house, use the
mounting brackets and hardware to mount the multiswitch.
a. Slide the mounting brackets on to the multiswitch.
b. Use the M6 hex head self tapping screws to mount the multiswitch.
M6 Hex Head Self Tapping Screw
(Multi-Switch Mounting)
Multiswitch Mounting
Hardware
Step 3: Make a
drip loop.
Step 2: Connect RG-6 cable to
grounding block.
Step-by-Step Instructions for Routing the Cables
1. Drill a hole in the location you want the coaxial cable to enter.
2. Place some silicone grease on the connector and connect the RG-6 coaxial cable
that will extend from the grounding block to the receiver.
3. Make a 3” - 5” drip loop using cable clips at the grounding block.
5. Route the coaxial cable through your house to appropriate connectors on the
Multiswitch (Satellite A or B).
6. Once you have routed all four cables to the correct inputs on the multiswitch, you
need to route one cable from the multiswitch to the back of the digital satellite
receiver, HDTV, or HD set-top converter. You can use any of the four outputs on
the multiswitch.