Radio Shack 43-3546 - Manual (Page 9)

U
si
ng Yo
ur
P
ho
ne
9
2. Press MEM . The TALK/BATT LOW flashes.
Ô
3. Enter the phone number, up to 20 digits. If a pause is
needed during the dialing sequence, press PAUSE/
REDIAL to insert a pause. Each pause counts as a digit
and represents a two second delay in time between
digits as they are sent.
4. Press MEM again.
To actually store a number in it’s designated location;
5. Press SPEED DIAL or memory location ( 0 - 9 ) on the
keypad to store a number.
A tone indicates that the number is stored. If you enter a
number in a location that has a previously stored number, it
will overwrite the existing number without warning.
Dialing a Memory Number
1. Press TALK . Then press MEM .
2. Enter the memory location ( 0 - 9 ) on the keypad. The
stored number automatically dials.
Ô
One-touch Speed Dial
Your phone is equipped with “One-touch speed dial” for
instant dialing. It is used to dial the phone number stored in
the one-touch speed dial location (See “Storing a Phone
Number in Memory” on page 8).
To instantly dial the phone number stored in the one-touch
speed dial location, simply press
SPEED DIAL . (There is no
need to press TALK . The phone will automatically dial). If
you press SPEED DIAL and a phone number is not stored in
the one-touch speed dial location, the handset will beep
rapidly and the phone will not dial.
Chain Dialing
The memory locations on the handset are not limited to
phone numbers. You can also store a group of numbers (up
to 20 digits) that you need to enter once your call connects.
This is referred to as Chain Dialing.
An example of this is a bank account number. Once you
have called your bank, and are prompted to enter the
account number, simply press
MEM and the location number
( 0 - 9 ) where the special number has been stored.
Store your special number in memory as you would store a
phone number (Refer to “Storing a Phone Number in
Memory” on page 8).
Erasing a Stored Number from Memory
1. Remove the handset from the base unit.
2. Press MEM twice.
3. Press SPEED DIAL or the memory location ( 0 - 9 ). A tone
indicates that the stored number is erased from
memory.
Ô
NOTES
Ô
Storing a Phone Number in
Memory
• The pause button counts as one
digit. Pressing PAUSE/REDIAL
more than once increases the
length of pause between
numbers.
• You have 30 seconds after
pressing MEM to enter the
number you wish to store.
Otherwise, the handset will
beep rapidly.
• Memory location for the speed
dial is independent from the
memory location for Memory
Dial.
Dialing a Memory Number
If you select a memory location that
does not have a stored number,
the handset will beep rapidly and
the phone will not dial.
43-3556.fm 9 ページ ２００４年１月２８日 水曜日 午前１０時５２分