Zanussi ZRT 724 W User Manual

Page 47

1. Remove the plug from

the power socket.

2. Open the door of the

freezer. Loosen the hinge.

3. Remove the doors by

pulling them slightly and

remove the hinge.

4. On the opposite side, re-

move the hole covers.

5. Unscrew both adjustable

feet and the screws of the

bottom door hinge. Remove

the bottom door hinge and

install it on the opposite

side.

6. Unscrew the bottom far

side screw and install on

the opposite side.

7. Unscrew the top door

holding pin.

8. Screw the pin back on

the other side.

9. Fit the doors into the

pins and install the doors.

Install the hinge.

10. On the opposite site,

install the hole covers.

11. Tighten the hinge.

Make sure that the doors

are aligned.

12. Remove and install the
handle

13. Reposition, level the

appliance, wait for at least

four hours and then con-

nect it to the power socket.

1) If foreseen

Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.

If the ambient temperature is cold (i.e. in Winter), the gas-

ket may not fit perfectly to the cabinet. In that case, wait

for the natural fitting of the gasket.

In case you do not want to carry out the above mentioned

operations, contact the nearest After Sales Service Force.

The After Sales Service specialist will carry out the rever-

sibility of the doors at your cost.