Roksan Audio Caspian - Manual (Page 20)

Disc Handling and Maintenance
Handling Precautions
Hold the disc by the edges so the surface will not be soiled
with fingerprints. (A)
Fingerprints, dirt and scratches can cause skipping and
distortion.
Do not write on the label side with a ballpoint pen or other
writing utensils.
Do not use record cleaning sprays, benzene, thinner, static
electricity prevention liquids or any other solvent.
Be careful not to drop or bend the disc.
Do not install more than 1 disc on the disc tray.
Do not try to close the disc tray when the disc is not
installed properly. (B)
Be sure to store the disc in its exclusive case when not in
use.
If the surface is soiled (C)
Wipe gently with a soft, damp (water only) cloth.
When wiping discs, always move the cloth from the center hole
toward the outer edge.
(If you wipe the discs using a circular motion, circular scratches are
likely to occur, which will cause noise.)
If the disc is brought from a cold to a warm
environment, moisture may form on the disc
Wipe this moisture off with a soft, dry, lint-free cloth before
using the disc.
Improper disc storage
You can damage discs if you store them in the following
places:
Areas exposed to direct sunlight
Humid or dusty areas
Areas directly exposed to a heat outlet or heating
appliance
Disc which cannot be played with this player
CD-ROM
CDV
CD-G
DVD with a Local No. other than that shown on the DVD
unit’s Region Code Label on the rear panel
Do not try to play Photo CD
Maintenance
Be sure to turn the unit off and disconnect the AC power
cord before maintaining the unit.
Wipe this unit with a dry soft cloth.
If the surfaces are extremely dirty, wipe clean with a cloth,
which has been dipped in a weak soap-and-water solution
and wrung out thoroughly, and then wipe again with a dry
cloth.
Never use alcohol, benzene, thinner, cleaning fluid or
other chemicals. And do not use compressed air to remove
dust.
(A)
(B)
(C)