beautypg.com

What to do if – Zanussi ZQF 11430 DA User Manual

Page 16

background image

4. leave the door/doors open to prevent unpleasant

smells.

Important! If the cabinet will be kept on, ask somebody to

check it once in a while to prevent the food inside from

spoiling in case of a power failure.

What to do if…

Warning! Before troubleshooting, disconnect the

mains plug from the mains socket.

Only a qualified electrician or competent person must do

the troubleshooting that is not in this manual.

Important! There are some sounds during normal use

(compressor, refrigerant circulation).

Problem

Possible cause

Solution

The appliance does not operate.

The Pilot light does not flash.

The appliance is switched off.

Switch on the appliance.

The mains plug is not connected to the

mains socket correctly.

Connect the mains plug to the mains

socket correctly.

The appliance has no power. There is

no voltage in the mains socket.

Connect a different electrical appliance

to the mains socket.

Contact a qualified electrician.

The Pilot light flashes.

The appliance is not working properly. Contact a qualified electrician.

The Alarm light flashes.

The temperature in the freezer is too

high.

Refer to "Excessive Temperature Alarm"

The acoustic alarm sounds

The temperature in the freezer is too

high.

Refer to "Excessive Temperature Alarm"

The compressor operates contin-

ually.

The temperature is not set correctly.

Set a higher temperature.

The door is not closed correctly.

Refer to "Closing the door".

The door has been opened too fre-

quently.

Do not keep the door open longer than

necessary.

The product temperature is too high.

Let the product temperature decrease to

room temperature before storage.

The room temperature is too high.

Decrease the room temperature.

The Fast Freeze function is switched

on.

Refer to "Fast Freeze function".

The temperature in the freezer is

too low.

The temperature regulator is not set

correctly.

Set a higher temperature.

The Fast Freeze function is switched

on.

Refer to" Fast Freeze function".

The temperature in the freezer is

too high.

The temperature regulator is not set

correctly.

Set a lower temperature.

The door is not closed correctly.

Refer to "Closing the door".

16