Ryobi RE180PL1 - Manual (Page 23)

23
ACCESSORIES
WARNING:
When using a UL listed router table, large router bits
should be used for edging only. Do not use router
bits that are larger in diameter than the opening in
the router base for any purpose. Failure to heed this
warning could result in serious personal injury.
WARNING:
Do not use with router tables that are not UL listed
and that fail to conform to safe woodworking prac-
tices and offer proper guarding for the cutter. Failure
to comply can result in an accident causing possible
serious injury.
WARNING:
The use of this router in table mounted applications
requires the use of the optional depth control knob.
Failure to use this optional depth control knob could
result in an accident and possible serious personal
injury.
OPTIONAL STRAIGHT GUIDE
An optional straight guide, part number 6090080, is
available and may be purchased for use with your router.
OPTIONAL DEPTH CONTROL KNOB
An optional depth control knob, part number 4830175, is
available, which allows you to easily adjust the depth of
cut when using the router mounted upside down to a
router table.
ROUTER TABLE
When mounting your router to a router table, use the two
5/16-18 UNC-2A flathead screws supplied. These screws
will secure your router to the router table properly. Use
of any other type and size screws could result in an
accident causing possible serious injury. Do not use
8 mm screws.