Razor ELECTRIC-POWERED GO KART 300001-SL - Manual (Page 6)

Tighten securely. Position the tie-rod control arm onto the steering
axle as shown in Figure 3a and install the washers and fixing bolt. Using
a 10 mm wrench, tighten securely.
Tighten the tie-rod control arm using a 5 mm hex key wrench.
Figure 3a Figure 3b
WARNING: Failure to use the washer and lock washer or failure to properly
tighten the steering wheel may cause you to lose control and crash.
❏
2 C. Attach the seat without seat belt assembly. Locate the
four (4) long seat attachment screw and spacer washers in the parts bag.
Position the seat over the frame and alighn it with the holes in the frame.
Insert the screws as shown in Figure 4a, using the spacer washer as
indicated by the arrow in Figure 4a. Insert all four screws and washers
and tighten securely using two Allen key wrenches as shown in Figure
4b.
Figure 4a Figure 4b