Remington PG-300 - Manual (Page 4)

The MiniScreen shaver should be cleaned as follows:
■ Press the buttons at ends of screen head.
■ Remove head and shake out clippings.
■ Blow/brush off cutter.
■ Replace head–make sure that it snaps in place.
■ DO NOT RINSE or OIL MINISCREEN SHAVER.
The unit has been lubricated at the factory.
Troubleshooting
The groomer does not work when turned on:
■ Groomer must be charged for a full 14-16 hours.
■ Contact an authorized Remington Service Center
regarding battery replacement.
Groomer cutters do not move:
■ The cutting unit may be dirty and clogged. Clean and
lubricate the unit as directed in the Cleaning
& Maintenance section.
Groomer does not hold charge:
■ Fully discharge battery by running groomer until it stops;
then follow recharging instructions (see section on
Charging/Recharging). If time between recharging cycles
does not increase, battery may need replacing.
Contact an authorized Remington Service Center.
You need help,
service information or locations:
Call 800-736-4648 for the authorized Remington Service
Center closest to you in the U.S. or 888 277-6333 in Canada.
Cleaning &
Maintenance con’
t
Pr
oduct
Featur
es
PG-300
This side for trimming
Nose, ear, eyebrow
This side for trimming
neckline & sideburns
Hair length attachment 1
Hair length attachment 2
Groomer
MiniScreen
shaver attachment
On/Off switch
G03-041 pg-300 web ib 9/1/05 9:45 AM Page 4