Ringdale IP Router - Manual (Page 11)

11
Troubleshooting and Technical Reference
Symptom Poss. Cause Action
LEDs do not flash Power switched off Switch on
at power-up
Power cord not connected Plug in Router
Fuse defect Replace fuse
Link LED does No cable inserted Connect to hub
not light up and Router
Router not Check power supply
powered up for Router
Wrong cable type Verify cable selection
Bad cable Replace cable
Technical Specification
Mains supply: Input: 90..240 volts AC
Frequency: 50..60Hz
Power: 3 watts typical
Network One Connection: Ethernet RJ45
Network Two Connection: Ethernet RJ45
Part No: 00-02-0342-0050