Radio Shack 3-IN-ONE POCKET REMOTE CONTROL 15-1990 User Manual
Page 8
8
TO OPERATE YOUR TV/VCR
COMBINATION
1. Locate the codes for your TV/VCR combination
in “TV/VCR Combinations” on Page 25 and
write down the codes for your brand of device on
the 3-in-One’s label.
2. Press
VCR
. The red light blinks.
3. Hold down
P
until the red light blinks twice, then
enter the 4-digit code you wrote down in Step 1
using these keys:
When the red light blinks twice, the remote con-
trol has accepted the code.
Note: If the code you entered is invalid, the red
light blinks.
4. Point the remote control at your TV/VCR combi-
nation and press
POWER
. Your device should
turn off (or on, if it was off).
If the remote does not operate your device, try
the other codes listed in “TV/VCR Combina-
tions” on Page 25 for your TV/VCR combination.
Note: Some TV/VCR combinations require a
second code to control volume. If you cannot
get the volume to work, use the TV code listed
in “TV VCR Combinations.” If no TV code is
listed, follow the instructions in “Punch-Through”
on Page 9 to control volume.
Press
To Enter
This Number
VOL +
1
VOL –
2
CH +
3
CH –
4
MUTE
5
15-1990.fm Page 8 Tuesday, December 14, 1999 12:45 PM