Radio Shack 3-IN-ONE POCKET REMOTE CONTROL 15-1990 - Manual (Page 27)

27
IF YOU HAVE PROBLEMS
MANUAL CODE SEARCH
If the 3-in-One Pocket Remote Control does not op-
erate your remote-controlled devices when you first
set it up, you might have to manually find the correct
code for your devices. You can try all the codes listed
in “Manufacturers’ Codes” on Page 11 for the brand
of your device, or you can follow these steps to
search the remote control’s entire library.
1. Manually turn on the device you want to set up.
2. Press the corresponding device key ( TV , VCR , or
CBL ).
3. Hold down P until the red light blinks twice, then
press MUTE , MUTE , then VOL – . The red light
blinks twice again.
4. Aim the remote control at the device you want to
operate.
5. Repeatedly press POWER then the device key
until the device turns off.
6. When the device turns off, press P within 10
seconds to save the code.
Note: If you do not press P within 10 seconds,
the remote control does not save the code.
• Because the remote control’s library has so
many codes, this procedure can take several
minutes.
• If your device turns off during the search, but
does not operate after you lock in the code,
begin the search again, pausing longer
between key presses.
If necessary, repeat these steps for each device.
15-1990.fm Page 27 Tuesday, December 14, 1999 12:45 PM