Raypak XTHERM 1005 - Manual

Project Name / Date
WATER-TUBE POOL HEATERS
PART 1 - GENERAL
1.1 SUMMARY
A. Section includes condensing, gas-fired copper finned-tube, gas domestic pool heaters
Specifier Note: Use as needed
B. Related Sections
1. Building Services Piping – Division 22 10 00
2. Breeching, Chimneys, and Stacks (Venting) – Division 23 51 00
3. Electrical – Division 23 09 33
1.2 REFERENCES
A. ANSI Z21.10.3/CSA 4.3
B. ASME, Sections IV and VIII
C. 2006 UMC, Section 1107.6
D. ANSI/ASHRAE 15-1994, Section 8.13.6
E. National Fuel Gas Code, ANSI Z223.1/NFPA 54
F. National Electrical Code, ANSI/NFPA 70
G. ASME CSD-1, 2009 (when required)
1.3 SUBMITTALS
A. Product data sheet (including dimensions, rated capacities, shipping weights, accessories)
B. Wiring
diagram
C. Warranty information
D. Installation and operating instructions
1.4 QUALITY ASSURANCE
A. Regulatory Requirements
1. ANSI Z21.10.3/CSA 4.3
2. Local and national air quality regulations for low NOx (0-20 PPM NOx emissions) pool heaters
B. Certifications
1. CSA
2. ASME HLW Stamp and National Board Listed – Primary
3. ASME U Stamp and National Board Listed – Secondary
4. ISO
9001
1.5 WARRANTY
A. Limited one-year warranty from date of installation
B. Limited twenty-five-year thermal shock warranty
C. Limited five-year primary heat exchanger warranty
D. Limited ten-year secondary heat exchanger warranty
PART 2 - PRODUCTS
2.1 MANUFACTURER
A. Raypak, Inc.
1. Contact: 2151 Eastman Ave., Oxnard, CA 93030; Telephone: (805) 278-5300;
Fax: (800) 872-9725; Web site: www.raypak.com
2. Product: XTherm™ condensing copper finned-tube pool heater(s)
Catalog No.: 6000.63A
Effective: 9-01-09
Replaces: 9-15-08
XTHERM™, TYPE WHP - MODELS 1005-2005
SUGGESTED SPECIFICATIONS