Remote Technologies IR-PRO T3 User Manual
Page 14
Introduction
7
GETTING STARTED
Start by inserting the battery connector into the mating plug on
the T3. Make sure the connector is oriented properly before
attempting to insert it. Next, turn the unit on by sliding the power
switch into the “ON” position (toward the battery).
After power is applied, the T3 will take approximately ten seconds
to load the operating system, the application software, and the
user program. This long delay only occurs from a power-down
state. During normal use the T3 turns-on instantly from its sleep
mode.
The T3 is turned-on by touching any area of the display or any
keypad button. If the tilt sensor is enabled, picking up the unit
will also turn it on.