Ratoc Systems CB31U - Manual (Page 58)

MS-DOS
56
5. How to install Windows 95/98
5-2. Making a Windows 95 startup floppy disk
This section gives you information on how to make a startup flopply disk on your own when the
MKDISK.EXE does not work. With the startup floppy disk, you can access to the SCSI CD-ROM drive
connected to the CB31U and install Windows 95 from the SCSI CD-ROM drive connected to the CB31U.
Follow the steps through to make a Windows 95 startup floppy disk
1.Edit Config.sys file in a Windows 95 startup floppy disk
Edit config.sys file in a Windows 95 startup floppy disk as shown below.(This is an example)
DEVICE = HIMEM.SYS
DEVICE = EMM386.EXE X = CC00-CFFF
BUFFERS = 10
FILES = 20
DEVICE = CBENABLE.EXE IRQ = A MEM = CC00
DEVICE = ASPCB3x.SYS /V
DEVICE = REXCD.SYS /D:MSCD001 /E
NOTE: CBENABLE.EXE is CardBus Enabler. Refer to CBENABLE.EXE parameter.
ASPCB3x.SYS is ASPI Manager. Refer to ASPCB3x.SYS parameter.
REXCD.SYS is CD-ROM driver. Refer to REXCD.SYS parameter.
2.Make Autoexec.bat file in the Windows 95 startup floppy disk and edit it as shown below.
@echo off
MSCDEX.EXE /D:MSCD001
3. a.Copy the CBENABLE.EXE, ASPCB3x.SYS, REXCD.SYS in the [Dos] folder in the CB31U
floppy disk for Windows98/95 to the Windows 95 startup floppy disk.
b.Copy the EMM386.EXE and MSCDEX.EXE in your system to the Windows 95 startup floppy disk.
4.Insert the Windows95 startup floppy disk and start your PC.
The SCSI CD-ROM will be assigned and you can access to the SCSI CD-ROM drive. You can install
Windows 95 from the SCSI CD-ROM drives.