Radio Shack DX-395 - Manual (Page 7)

7
RADIO OPERATION
TUNING THE RADIO
1. Set the volume to its lowest set-
ting, and lift up and extend the
antenna.
2. Set ON/OFF to ON to turn on the
radio. The last frequency tuned
is automatically selected and
displayed.
3. Slide FM/AM/SW1/SW2 to the
desired band.
• FM — to receive signals in
the 87.5 to 107.9 MHz range
• AM — to receive signals in
the 530 to 1710 KHz range
• SW1 — to receive signals in
the 3.20 to 7.30 MHz range
• SW2 — to receive signals in
the 9.50 to 21.75 MHz range
4. Set SENS to DX or LOC .
• DX — to receive weak signals
• LOC — to receive strong
(local) signals
Note: SENS only functions for
FM and shortwave reception.
5. Press TUNING or to tune
to the desired station.
Note: To automatically tune the
radio to the next strong signal,
press and hold
TUNING or
for about 2 seconds.
6. Adjust the volume to a comfort-
able level.
7. Set the tone switch to HI or LO .
• HI — to enhance music
• LO — to enhance speech
8. Set ON/OFF to OFF to turn off
the radio.
20-225.fm Page 7 Wednesday, August 4, 1999 10:07 AM