New Transducers TR-5001 - Manual (Page 74)

Primary/Secondary Master/Slave UDMA
Ultra DMA/33/66/100 implementation is possible only if your IDE
hard drive and cable supports it and the operating environment includes
a UDMA driver If your hard drive and your system software both
support Ultra DMA/33/66/100, select Auto to enable BIOS support.
The System BIOS will also check the IDE cable. Only if the 80-way
ATA66/100 cable is installed, the ATA66/100 models can be enabled
by the OS driver. Otherwise, the system will be limited to run up to
ATA33 mode.
The Choice: Auto, Disabled.
On-Chip Serial ATA Setting
SATA Mode
On-Chip Serial ATA
Disabled Disabled SATA Controller.
Auto Auto arrange by BIOS.
Combined
Mode
PATA and SATA are combined. Max. of 2 IDE
drives in each channel.
Enhanced
Mode
Enable both SATA and PATA. Max. of 6 IDE
drives are supported.
SATA Only SATA is operating in legacy mode
Serial ATA Port0 Mode
The choice: Primary Master, Primary Slave, Secondary Master,
Secondary Slave, Primary Master, Secondary Master, SATA0 master,
SATA1 master.
Serial ATA Port1 Mode
The choice: Primary Master, Primary Slave, Secondary Master,
Secondary Slave, Primary Master, Secondary Master, SATA0 master,
SATA1 master.
70 TR-5001 User Manual