NHT SubOne i - Manual (Page 12)

This method of connection is recommended if you have a receiver with no line level preamplifier output of any sort and you want your
L & R speakers to receive a high-pass filtered signal. The SubOne i Controller may be connected to the system at speaker level between
the receiver and the speakers. The SubOne i Controller’s speaker-level output has a fixed 100Hz high-pass filter that removes fre-
quencies below 100Hz before sending the signal on to the speakers. The speaker-level high-pass filter is not adjustable. This method
is not recommended if the L & R speakers are large, full range models.
1) Connect a pair of speaker cables from your receiver’s front L & R speaker output terminals to the SubOne i Controller’s INPUT FROM
AMPLIFIER barrier strip.
2) Connect a second pair of speaker cables from the SubOne i Controller’s OUTPUT TO SATELLITES barrier strip to the front L & R
speakers.
3) If your receiver is equipped with a "Subwoofer Out" or "LFE Out" jack, you may connect from this jack to the LFE Input on the
Controller with an RCA cable. See page 6 for information on the LFE Input and the LFE Gain control.
4) Connect the SubTwo i Controller’s SUBWOOFER OUTPUT to the SubTwo i input terminal with the supplied RCA cable.
Connect the SubOne i Controller at speaker level from the receiver’s speaker outputs,
with fixed high-pass filter
Use if:
You wish to send your L & R speakers a high-pass filtered signal
Your receiver has no “Pre-Out”, “Line Out” or “Subwoofer Out” jacks
S u b O n e i C o n n e c t i o n M e t h o d # 3
10
SubOne i
Connection Method #3