Nuvo NV-T2SIR - Manual (Page 12)

7
I. Installing the T2SIR in the Home
Connecting the Audio Outputs (Fig. 1)
The T2SIR has two independent audio outputs labeled A and B.
These are standard stereo RCA connections and can be
connected to any device designed to receive an analog stereo
audio signal.
Setting the Audio Outputs for NuVoNet or Standalone use
(Fig. 2)
The outputs A and B are individually set from the front panel
display of the T2SIR. When the Tuner is initially plugged into
an AC power source, a short setup wizard will appear on the
display. A message, “Uninitialized State Detected (Press OK)”
will appear. When OK is pressed, the prompt is to select a
regional tuning standard. The choices are USA/Canada,
Western Europe, Australia, and New Zealand. Use the Up and
Down arrows to highlight the appropriate choice and touch the
OK button to select this. Once regional tuning has been
selected, the display will prompt for the use of each output A
and B. “+Output A” will highlight automatically. Using the Up
and Down arrows on the front panel, move the highlight to the
appropriate use of the Tuner output and touch OK. The choices
are Stand Alone, Source 1, Source 2, Source 3, Source 4, Source
5, and Source 6. For any use other than with the Essentia E6G
or Grand Concerto Systems, select Standalone. This will require
IR or serial control of the T2SIR's functions. Highlighting the
appropriate Source number input for the NuVo system and
touching the OK button sets NuVoNet communication. Once
Output A is set, the highlight will move to Output B. For
operation, both outputs A and B must be set as Standalone or
as a NuVoNet Source.
When the Tuner's outputs are set, they will return to AM 530, or
the minimum AM band setting for the selected regional tuning
parameters. At this point the T2SIR is ready for either NuVoNet
communication or standalone use, depending on the setting
made for both outputs.
ANTENNA
IN
USE NV-T2FAA
ANTENNA
L
AUDIO
R
TUNER A
SIRIUS L
AUDIO
R
TUNER B
SIRIUS
SOURCE LINK
L
R
L
R
L
R
SOURCE INPUTS
TIP=L RING=R
ZONE 2
VARIABLE OUTPUT
FIXED OUTPUT
TIP=L
RING=R
VARIABLE OUTPUT
FIXED OUTPUT
TIP=L
RING=R
VARIABLE OUTPUT
FIXED OUTPUT
TIP=L
RING=R
1 2 3 4 5 6
1 2 3 4 5 6
1 2 3
4
CONNECT TO NV-I8X
USE NV-SLC1 CABLE
5 6
ZONE 1
VARIABLE OUTPUT
FIXED OUTPUT
SPEAKER
40W/6 OHMS X 2 LEFT RIGHT
ZONE 3 ZONE 4
SOURCE STATUS
SPEAKER
40W/6 OHMS X 2 LEFT RIGHT
SPEAKER 40W/6 OHMS X 2
LEFT RIGHT
SPEAKER
40W/6 OHMS X 2 LEFT RIGHT
Fig. 1
Fig. 2
MENU
BAND OK
A/B DISP
Uninitialized
State Detected
(Press OK)
MENU
BAND OK
A/B DISP
Regional Setup
US and Canada
Western Europe
Australia
MENU
BAND OK
A/B DISP
Set TunerA Mode
Standalone
Source 1
Source 2