NAD L70 - Manual (Page 12)

12
INPUT SELECTOR
• From the OSD’s
remotes’ and “Enter” keys.
• Using the keys select the video input (DVD, SAT, VCR, and VIDEO 4) you wish to configure.
• Use the keys to move to the line, and then use the keys to select the analog
audio input you wish to be linked to that input (usually, this will be the same, i.e., “VCR” with “VCR,”
“Video 4” with “Video 4,” and so on).
NOTE
It is not necessary to have an analog audio input connected for every video input you employ. In fact,
in some cases-for example for a CAB/SAT-it may be preferable to make only a coaxial or optical digital
audio link to the L70 for audio playback. This avoids possible confusion, and ensures that the L70’s
high-performance surround and digital audio circuitry will always be employed.
• Now use the keys to move to the line and select the digital input you wish
linked to that input.
• If you set to “ANALOG,” no incoming digital signal will be selected by that input.
(Set an input’s to “ANALOG” only if you wish to ensure that that input will not play
an incoming digital bit stream, even if one is present.)
NOTE
• The combination of analog-audio input and digital input assigned above will always be recalled
whenever that input is selected via the front-panel INPUT SELECTOR, or the HTR L70 remote’s input-
select keys.
• That signals from digital inputs are not available on the analog VCR OUT jacks.
SETTING UP THE L70
Setup
ENGLISH
FRANÇAIS
DEUTSCH
NEDERLANDS
ESP
AÑOL
IT
ALIANO
POR
TUGUÊS
SVENSKA