Nuvo NV-E6DMS-DC User Manual
Page 26
Command to determine when the desired volume point has been reached. Note that ramps in different zones may start at
different levels and will all ramp at the same rate.
*********************************************************************************
COMMAND:
*
Ramp ALL zones DOWN at a 10 dB/second rate in 1 dB steps.
RESPONSE:
#
The ramp action will be cancelled when all zones reach MINIMUM (OFF) volume, or when an
Command is
received. Note that to stop the ramp with this command before the minimum volume, one reference zone must be periodically
polled with a
Command to determine when the desired volume point has been reached. Note that ramps in
different zones may start at different levels and will all ramp at the same rate.
*********************************************************************************
COMMAND:
*
Stops ramp action initiated by
Or
RESPONSE:
#
This results in a HOLD of the level at time of command receipt.
*********************************************************************************
COMMAND:
*
ALL MUTE ON.
RESPONSE:
#
*********************************************************************************
COMMAND:
*
ALL MUTE OFF.
RESPONSE:
#
********************************************************************************
COMMAND:
*
Switch zone xx to SOURCE p ( 1 to 6).
RESPONSE:
Same response as for
*********************************************************************************
COMMAND:
*
Set volume of zone xx to level yy below max in dB from 0 to 78 dB (include lead 0 for all
single-digit values).
RESPONSE:
Same response as for
*********************************************************************************
COMMAND:
*
STARTS zone xx volume ramp UP at the rate of +10 dB per second in +1 dB steps. (This is
the same as holding VOLUME UP key on a KEYPAD for 1 second).
RESPONSE:
Same response as for
*********************************************************************************
COMMAND:
*
STARTS zone xx volume ramp DOWN at the rate of -10 dB per second in -1 dB steps. (This
is the same as holding VOLUME UP key on a KEYPAD for 1 second).
RESPONSE:
*********************************************************************************
COMMAND:
*
STOPS zone xx volume ramp initiated by
or
commands.
This results in a HOLD of the level at time of command receipt.
RESPONSE:
#
*********************************************************************************
COMMAND:
*
zone xx MUTE ON (mutes currently connected source)
RESPONSE:
ALLV-
ALLV-
*ALLHLD
*ZxxCONSR
ALLHLD
*ALLV+
*ALLV-
ALLHLD-
ALLMON
ALLMON
ALLMOFF
ALLMOFF
ZxxSRCp
*ZxxCONSR
ZxxVOLyy
*ZxxCONSR
ZxxVOL+
*ZxxCONSR
ZxxVOL-
Same response as for *ZxxCONSR
ZxxVHLD
*ZxxVOL++
*ZxxVOL--
ZxxVHLD
ZxxMTON
Same response as for *ZxxCONSR
25