NordicTrack NTSY59210 - Manual (Page 15)

15
32. Wrap the High Cable (100) around a 115mm
Pulley (54). Attach the Pulley and a Cable Trap
(52) to the bottom set of holes in the indicated
pair of Pulley Plates (35) with an M10 x 50mm
Bolt (77) and an M10 Nylon Locknut (93). Be
sure the Cable Trap is turned to hold the
Cable in the groove of the Pulley.
33. Route the High Cable (100) under a 115mm
Pulley (54) and through the Press Upright (16).
Attach the Pulley inside the Upright with an M10 x
65mm Bolt (88), two M10 Washers (89), two
15mm x 12mm Spacers (62), and an M10 Nylon
Locknut (93).
31. Wrap the High Cable (100) around a 115mm
Pulley (54). Attach the Pulley to the bracket on
the Press Base (1) with an M10 x 45mm Bolt (86)
and an M10 Nylon Locknut (93).
31
32
33
34. Route the High Cable (100) under a 115mm
Pulley (54) and through the Seat Frame (3).
Attach the Pulley inside the Seat Frame with an
M10 x 65mm Bolt (88), two M10 Washers (89),
two 15mm x 12mm Spacers (62), and an M10
Nylon Locknut (93).
34
86
1
100
54
93
93
77
35
52
54
100
88
89
89
62
62
93
16
54
100
100
62
62 93
89
88
89
54
3