Napoleon Grills 485RSIB - Manual (Page 32)

32
www.napoleongrills.com
Item Part # Description RSIB
1 N135-0024K left side lid casting x
2 N385-0129 NAPOLEON logo x
3 W450-0005 logo spring clips x
4 N510-0010 black silicone lid bumper x
5 N685-0009 temperature gauge x
7 N335-0042L stainless steel lid insert x
8 N570-0080 #14 x 1/2” screw x
9 N010-0504 lid handle x
10 N135-0025K right side lid casting x
11 N570-0015 lid pivot screw x
12 N010-0565 hood assembly x
13 N570-0008 #8 x 1/2” screw x
14 N570-0073 1/4-20 x 3/8” screw x
15 N735-0003 1/4” lockwasher x
16 N520-0023 warming rack x
17 N305-0063 cooking grids - cast iron x
N370-0597 cooking grids - wave stainless rod ac
18 N305-0057-M05 sear plate x
19 N010-0617 stainless steel side burner shelf - right x
20 N120-0009 LUXIDIO side shelf end cap, right x
21 N570-0082 1/4-20 x 5/8” screw x
22 N010-0616 stainless steel ice bucket side shelf - left x
23 N120-0008 LUXIDIO side shelf end cap, left x
24 N200-0090-M06 infra red rear burner cover x
25 N010-0526N infra red rear burner n
N010-0526P infra red rear burner p
N455-0053 rear burner orifice #53 n
N455-0054 rear burner orifice #59 p
N720-0053 rear burner supply tube x
26 N240-0024N rear burner electrode c/w pilot n
N240-0024P rear burner electrode c/w pilot p
27 N080-0206 rear burner electrode cover x
28 N570-0079 rear burner electrode cover screw x
N615-0011 rear burner electrode cover spacer x
29 N100-0036 main burner x
30 N080-0202-M05 main burner cross light bracket x
31 N475-0199-M06 rotisserie mount x
32 N010-0500 base x
33 N010-0501-M08 drip pan x
34 N160-0014 grease tray holder x
35 N185-0001 replacement grease tray aluminium x
36 N200-0089P back cover x
37 N475-0253CT control panel x
38 N380-0011 control knob x
39 N051-0006 control knob bezel x
40 N530-0003 1-outlet regulator p
Leak Testing Instructions
WARNING!
A leak test must be performed annually and each time a cylinder is hooked up or if a part
of the gas system is replaced.
WARNING!
Never use an open flame to check for gas leaks. Be certain no sparks or open flames are in
the area while you check for leaks. Sparks or open flames will result in a fire or explosion, damage to property,
serious bodily injury, or death.
Leak testing: This must be done before initial use, annually, and whenever any gas components are replaced
or serviced. Do not smoke while performing this test, and remove all sources of ignition. See Leak Testing Dia-
gram for areas to check. Turn all burner controls to the off position. Turn gas supply valve on.
Brush a half-and-half solution of liquid soap and water onto all joints and connections of the regulator, hose,
manifolds and valves.
Bubbles will indicate a gas leak. Either tighten the loose joint or have the part replaced with one recommended
by the Napoleon Customer Care department and have the grill inspected by a certified gas installer.
If the leak cannot be stopped, immediately shut off the gas supply, disconnect it, and have the grill inspected
by a certified gas installer or dealer. Do not use the grill until the leak has been corrected.