Napoleon Fireplaces NPI40 - Manual (Page 6)

W415-0616 / C / 06.04.08
6
GENERAL INTRODUCTION
GENERAL INSTRUCTIONS
Thank you for purchasing the Wolf Steel Ltd. Pellet Heater.
This heater is designed for use with Pelletized Wood Only.
Please read this entire manual before installation and use of this pellet fuel-burning room heater. Failure to follow
these instructions could result in property damage, bodily injury or even death.
Keep this manual handy for future reference.
This Pellet Heater, when installed, must be electrically grounded in accordance with the local codes, or in the absence
of local codes, use the current CSA C22.1 Canadian Electrical Code in Canada or the ANSI/NFPA 70 National Electrical
Code in the United States.
This heater will not operate using natural draft or without a power source for the blower systems and fuel feed system.
PELLET QUALITY
Pellet quality is important, please read the following:
Your Wolf Steel Ltd. Pellet Heater has been designed to burn premium hard or soft wood pellets only. Do not use
any other type of fuel such as fi re logs or fi re starting pellet, as this will void the warranties stated in this manual.
The performance and heat output of the pellet heater is directly related to the quality and moisture of the pellets.
Store pellets in a cool dry area to prevent moisture absorption.
P.F.I. PELLET STANDARDS:
If the fuel does not comply to this standard the unit may not operate as designed.
We recommend the use of premium grade (1% ash content) for longer stove life and less frequent cleaning.
Fines (fi ne particles) 1% maximum through a 1/8" screen
Bulk Density 40 pound per cubic foot minimum
Size 1/4" to 5/16" diameter, 1/2" - 1 1/2" long maximum
Ash Content 1% maximum (Premium grade)
3% maximum (Standard grade)
Moisture Content 8% maximum
Heat Content Approximately 8200 BTU per pound minimum
Approximate Maximum Heating Capacity (in square feet)* 800 to 2000 Sq. Feet
Burn Rate (Pounds per Hour)** 1.0 to 5.0
Maximum Burn Time on Low Burn** 55 Hours (NPS40), 45 Hours (NPI40)
Hopper Capacity 55 Pounds (NPS40), 45 Pounds (NPI40)
* Heating capacity will vary depending on the home's fl oor plan, degree of insulation, and the outside temperature. It is
also affected by the fuel size, quality, and moisture level.
** Small pellets will increase or decrease the stated burn rates and burn times. Differences of plus or minus 20% de-
pending on fuel quality may occur.
HEATING SPECIFICATIONS
It is important to select and use only pellets that are dry and free of dirt or any impurities such as high salt con-
tent. Dirty fuel will adversely affect the operation and performance of the unit and will void the warranty. The
Pellet Fuel Industries (P.F.I.) has established standards for wood pellet manufacturers. We recommend the use
of pellets that meet or exceed these standards. Ask your dealer for a recommended pellet type.
!
WARNING
SPECIFICATIONS