Nikon UPS - Manual (Page 4)

UPS/400
. . . an IBM AS/400 UPS power monitoring system . . .
4
I
NSTALLATION
/R
EINSTALLATION
I
NSTRUCTIONS
If you are installing UPS/400 for the first time or reinstalling, the instructions are the same. The program will
install the product for you. If you are re-installing UPS/400, the installation program will create a library
(UPSMBKU) where it will back up the library UPS400 before it begins installation. At the end of a
successful installation, you can delete the library UPSMBKU. If you are using UPS/400 with multiple
AS/400s in an APPN network environment, you must load a copy of UPS/400 on each machine that is to be
monitored in the network.
Sign on as QSECOFR and load the distribution media or follow instructions below for internet download.
First Installation — CD
1. Load CD into the CD-ROM drive
2. Enter the following command: LODRUN DEV(*OPT)
3. The CD-ROM product installation menu is displayed. To install UPS/400, please enter a
1 beside UPS/400.
4. The product information will automatically be installed.
5. Use the command STRUPS400 to access the UPS/400 Main Menu.
First Installation — Tape
1. Load tape in the appropriate drive
2. At the command line type: RSTLIB SAVLIB(MBAINST) DEV(device name)
3. Execute the install command:
MBAINST/MBAINST PRODUCT(UPS) ACTION(*INSTALL) DEV(device name)
4. Use the command GO ICM to access the ICOM/400 Main Menu.
Upgrade
1. Back-up your current UPS/400 system (library UPS400).
2. Follow steps for the proper media format above.
3. NOTE: If you are upgrading to a new system, you will need to restore the old product
library on the new system before proceeding with step 1.