Nilfisk-Advance America P 130.2 - Manual (Page 13)

13
Nilfisk P 130.2 / P 150.2 / P 160.2
EN

6 After using your pressure washer
6.2 Winding up of electric
cable and high pressure
hose
up carefully.
1. Wind up the electric cable on
the appropriate hooks. Built-
in clip for good holding.
The lower hook can be
turned to release the electric
cable.
2. The high pressure washer
comes in two models: A) with
hook for storage of high pres-
sure hose (14) - B) with a
hose reel (13).
6.1 Storing the washer The machine should be sto-
red in a frost-free room!
Pump, hose and accessories
should always be emptied of
water prior to storing as follows:
1. Stop the machine (turn the
start/stop switch (1) to posi-
tion “O” and detach water
hose and accessory.
2. Restart the machine and
activate the trigger. Let the
machine run until no more
water runs through the spray
handle.
3. Stop the machine and un-
plug. Wind the electric cable
round the hooks placed on
the side of the machine.
4. Separate spray handle and
high pressure hose.
5. Machines without hose reel:
Detach high pres sure hose,
coil it up and place it on the
hose storage.
Machines with hose reel: Coil
the high pressure hose up on
the hose reel.
6. Place spray handle, nozzles
and other ac ces so ries in the
holders of the machine.
Should the machine by mistake
be frozen, it will be necessary
to check it for damage.
NEVER START-UP A FROZEN
MACHINE.
Frost damages are not
covered by the guarantee!
6.3 Storage of accessories
The standard accessories
(spray handle, spray lance,
nozzles and nozzle cleaning
tool) can be stored on the pres-
sure washer.
To avoid accidents, the electric
cable and the high pressure
hose should always be wound