NEC 110 User Manual

Page 35

Using the MH 110 Wireless Telephone 2-11

Mobile Handset 110 Wireless Telephone and Desktop Charger User Guide - Revision

Step 2

Slide the lip of the Battery Pack into the bottom of the cavity.

Step 3

Push the top of the Battery Pack until it snaps into place.

Changing the Battery Pack During a Call

The Battery Pack may be changed while a call is still in progress. Use the

following steps to remove and replace the battery pack while in a call.

Step 1

Quickly remove the discharged Battery Pack and replace with a charged
Battery Pack.

Step 2

Press Power On/Start Call to turn the Wireless Telephone back on.

Step 3

Press Power On/Start Call again to resume the call in progress.

Users of IP telephony interfaces not requiring the UNIVERGE WL System

Telephony Gateway should Park a call prior to changing the Battery Pack

during an active call. The call should then be retrieved after the Battery

Pack is replaced to rejoin the conversation.

NOTE

You should not have to force the Battery Pack into the Wireless Telephone.

NOTE

If you are using the Telephony Gateway in your telephone system, do not press

Power Off/End Call on the Wireless Telephone before beginning the following

steps.

REFERENCE

Refer to

for detailed

instructions.

REFERENCE

Check with the switch administrator for instruction on how to perform this or a similar

process on your particular telephone system.