Nokia 730C - Manual (Page 7)

6 Getting Started Nokia 730C
E
N
G
L
I
S
H
Installation is complete!
Enjoy your new 730C Monitor!
To be best prepared for any future
customer service needs:
• Write the serial number (see back
of the monitor) in "For your Records"
on page 1 of this guide.
Quick Installation
1 Connect video cable
Make sure both the monitor and the
computer are powered OFF. Connect the
video cable to the computer.
Macintosh users: Connect a Macintosh
adapter to the video cable, then to the
computer. For information about Mac
adapters contact your dealer. You will
need to provide your monitor's serial
number.
2 Connect power cord
Connect the power cord to a properly
grounded AC outlet, then to the monitor.
3 Power-ON monitor and computer
Power-ON the monitor, then power-ON
the computer. This sequence (monitor
before computer) is very important.
NOTE: At this point Windows ® 98 users
may receive a message asking them to
install the 730C’s INF file.
4 Install INF and ICM files
• For CD-ROM: Insert the CD-ROM
into your system, wait for it to auto-
start, select “Monitor Drivers,” and
follow the on-screen instructions.
• For diskette: Insert the diskette into
your system, run setup.exe, and
follow the on-screen instructions.
5 Windows users: Setting the
Timing Mode ( resolution and refresh
rate) Example: 1024x768@ 75Hz.
For instructions on changing the resolu-
tion and refresh rate, see the user guide
for your computer's graphics card.
6 Use the OnView ® controls to
adjust the screen image.
See the Operations section in this
guide.
Power Cords
Video Cable