Nordyne R-410A User Manual

Page 3

2. Set the thermostat temperature to the

desired temperature level using the
temperature selector. Please refer to
the separate detailed thermostat user’s
manual for complete instructions regarding
thermostat programming. The outdoor unit
and indoor blower will both cycle on and
off to maintain the indoor temperature at
the desired heating level.

NOTE: If the thermostat temperature level
is re-adjusted, or the thermostat system
switch is repositioned, the outdoor unit
may not start immediately. The outdoor unit
contains a protective timer circuit which
holds the unit off for approximately fi ve
minutes following a previous operation,
or the interruption of the main electrical
power.

Emergency

Heat:

The thermostat includes a system switch
position termed EM. HT. This is a back-up
heating mode to be used only if there is
a suspected problem with the outdoor
unit. With the system switch set to EM.
HT. the outdoor unit will be locked off,
and supplemental heat (typically electric
resistance heating) will be used as a source
of heat. Sustained use of electric resistance
heat in place of the heat pump will result
in an increase in electric utility costs.

Defrost:

During cold weather heating operation,

the outdoor unit will develop a coating

Figure 1. Typical Thermostat

OPERATING INSTRUCTIONS

TO OPERATE YOUR HEAT PUMP

FOR COOLING —

1. Set the thermostat system switch to COOL

and the thermostat fan switch to AUTO. (See
Figure 1)

2. Set the thermostat temperature to the

desired temperature level using the tem-
perature selector. Please refer to the sepa-
rate detailed thermostat user’s manual for
complete instructions regarding thermostat
programming. The outdoor unit and indoor
blower will both cycle on and off to maintain
the indoor temperature at the desired cool-
ing level.

power.

TO OPERATE YOUR HEAT PUMP

FOR HEATING —

1. Set the thermostat system switch to HEAT

and the thermostat fan switch to AUTO.
(See Figure 1)