Nostalgia Electrics CCP200 - Manual (Page 10)

ENGLISH
8
Assembly of Wheels
Insert Axle Rod (F) into Base Support (I). 1.
Put on #5 Flat Washer. Slide Wheel (G) into Axle Rod (F) 2.
and add a second #5 Flat Washer.
Use the end of Wrench (H2) with small notch to hold the Axle Rod notch in place. 3.
While holding Axle Rod (F) in place, tighten the #6 Nut Cap with Wrench (H1).
Add #5 Flat Washer, second Wheel (G), another #5 Flat Washer, and #6 Nut 4.
Cap to the other side of the Axle Rod (F), following the directions above.
(#6)
Nut
Cap
(#5)
Flat
Washer
(F)
Axle
Rod
(G)
Wheel
(I)
Base
Support