Advice and safety – Nortel Networks M 902 User Manual
Page 25
PAGE 26
Note
You are about to use approved equipment of type
DECT, allowing intercommunication for private use bet-
ween cordless telephones and a cordless Private Automatic
Branch Exchange (PABX) or domestic radio bases. This
equipment can be used as long as the conditions specified
in the decree dated 13 January 1995 published in the
Official Bulletin 26 January 1995, which defines the condi-
tions of a general authorisation licence on the basis of
article L89 of the post and Telecommunication code.
Apart from the equipment approval, in fact, the follo-
wing operating instructions must be respected, especially
considering the radio-electric frequencies used:
1. Use of DECT equipment is not guaranteed against
jamming caused by other authorised use of radio electric
frequencies;
2. DECT equipment can only be used to establish links
between fixed points if these links are not permanent and if
the equivalent radiated isotropic power at the antenna is less
than 50 mW;
3. The installation of DECT equipment (of type cord-
less PABX including more than two access lines to the net-
work) must be carried out by an installer approved by the
minister responsible for telecommunications, since these
installations constitute complex installations within the
meaning of article R. 20-22 in the Post and
Telecommunication code.
4. The conditions of access to a DECT equipment tele-
point network must be defined in an agreement signed with
the operator of the authorised telepoint network concerned.
Electrical connection: 230 V AC monophase power
supply with the exclusion of installations with an IT-design
defined in the EN 60-950 standard. Note that the network
voltage is classified as excessive according to the criteria of
this same standard.
As a precautionary measure, in case of danger the mains
power supply block serves as a disconnecting device for the
230V power supply.
CE: This equipment complies with the requirements of
EMC Directive 89/336/EEC for Electromagnetic.
Compatibility and LVD Directive 73/23/EEC for Electrical
Safety as amended by Directive 93/68/EEC.
ADVICE AND SAFETY