NordicTrack NTMC29931 - Manual (Page 5)

4. If you are using a treadmill, remove the backing from
the adhesive strip on the Treadmill Receiver (6). Plug
the Treadmill Receiver into the iFIT jack on the con-
sole of your treadmill. Firmly press the Treadmill
Receiver onto the console.
iFIT Jack
4
5. If you are using an exercise cycle or an elliptical exer-
ciser, remove the backing from the adhesive strip on
the Bike/Elliptical Receiver (5). Plug the wire on the
Bike/Elliptical Receiver into the iFIT jack on the con-
sole of your exercise cycle or elliptical exerciser. Then,
firmly press the Bike/Elliptical Receiver onto the
console.
6. Remove the battery cover from the back of the
Remote Control (10). Insert two “AAA” batteries (not
included) into the battery receptacle;
make sure the
batteries are oriented according to the diagram
inside the battery receptacle. Reattach the battery
cover.
5
Wire
10
“AAA” Batteries
Battery Cover
5
6
6
5
iFIT Jack