NetComm IP DSLAM - Manual (Page 61)

NetComm NCT240 Management Guide Release 1.0
Command usage:
set
set ip
set netmask
set mac
set vlan
Gateway
Use this command to establish a static route between this device and management
stations that exist on another network segment.
Syntax: gateway
¾ gateway ip – the IP address of the gateway that you want to send the packets
through
Command usage :
gateway
*** the Device to which the Gateway is set will be selected automatically
Route
Use this command to display the routing table.
Syntax: route
¾ show – display the routing table
Command usage:
route
Ping
This is an IP facility to check for network functionality by sending an echo request to
another IP host and waiting for the replay
Syntax: ping [count]
¾ ip – the IP address of the target
¾ count – the number of pings you want the NCT240 to send
60