NAD T 514DVD - Manual (Page 10)

10
CONNECTING TO OPTIONAL EQUIPMENT
Connecting to an amplifier equipped with two channel analog
stereo or Dolby Pro Logic ll / Pro Logic
Connect the Left and Right AUDIO OUT connectors on the DVD Player
to the audio left and right in connectors on your amplifier, receiver, or
stereo system, using the audio cables (A).
Connecting to an amplifier equipped with two channel digital
stereo (PCM) or to an Audio / Video receiver equipped with a
multi-channel decoder (Dolby Digital™, MPEG 2, or DTS)
1 Connect one of the DVD Player’s DIGITAL AUDIO OUT connectors
(OPTICAL (O) or COAXIAL (X)) to the corresponding in jack on your
amplifier. Use an optional digital (optical (O) or coaxial (X)) audio
cable.
2 You will need to activate the player’s digital output. (See “Digital
Audio Output” on page 14).
DIGITAL MULTI-CHANNEL SOUND
A digital multi-channel connection provides the best sound quality. For
this you need a multi-channel Audio/Video receiver that supports one or
more of the audio formats supported by your DVD Player (MPEG 2,
Dolby Digital and DTS). Check the receiver manual and the logos on the
front of the receiver.
CAUTION
Due to the DTS Licensing agreement, the digital output will be in DTS
digital out when DTS audio stream is selected.
Rear of DVD player
Amplifier (Receiver)
NOTES
• If the audio format of the digital output does not match the
capabilities of your receiver, the receiver will produce a strong,
distorted sound or no sound at all.
• Six Channel Digital Surround Sound via digital connection can only
be obtained if your receiver is equipped with a Digital Multi-channel
decoder.
• To see the audio format of the current DVD in the onscreen display,
press AUDIO.
CONNECTIONS
Preparation
ENGLISH
FRANÇAIS
DEUTSCH
NEDERLANDS
ESP
AÑOL
IT
ALIANO
POR
TUGUÊS
SVENSKA
y
A X O
R L
AUDIO I NPUT DIGITAL I NPUT
OPTICAL COAXIAL
T514_eng.qxd 11/9/2004 1:01 PM Page 10