Nextel comm IR1200 User Manual
Page 47
Verifying Installation
RFM-4200-5015 Rev1
39
LED (signal indicators)
displays the modem’s
serial interface status.
Status LED
displays the
modem’s
iDEN network
status.
Diagnostic Connector
used to receive modem
diagnostic information.
Reset Button used to
power cycle the
modem and re-
establishes connection
to the network.
LED (signal indicators)
displays the modem’s
serial interface status.
Status LED
displays the
modem’s
iDEN network
status.
Diagnostic Connector
used to receive modem
diagnostic information.
Reset Button used to
power cycle the
modem and re-
establishes connection
to the network.
Figure 9 – iR1200 Front Panel Layout
Signal
Color
Indication
Tx
Blinking
Green
Modem is transmitting data to the
computer data terminal (DTE).
Rx
Blinking
Green
Modem is receiving data from the
computer. Modem is receiving data from
the DTE.
RTS
Green
(Off)
Request To Send from computer (DTE) is
asserted (not asserted).
CTS
Green
(Off)
Clear To Send from modem is asserted
(not asserted).
DTR
Green
(Off)
Data terminal equipment is ready (not
ready).
DSR
Green
(Off)
Modem is ready (not ready).
STATUS
Solid Red
The modem is searching for signal within
the Nextel network. If the modem status
changes from blinking green back to solid
red, the signal has been lost and the