Operation instructions – Newcon Optik LRB 6000CI User Manual
Page 14
10
5. OPERATION INSTRUCTIONS
Installing the battery
Open the battery compartment using a suitable tool,
or a coin.
Insert a 9V Lithium non-magnetic battery provided
with your device
Connect the battery to the battery snap
Refit the battery compartment and tighten the screw.
If the battery compartment cover does not close tightly
and evenly, check that the battery snap wires are neatly
packed inside the battery compartment and the cover is
aligned over the edge of the battery compartment.
Note: Battery in metal casing will diminish compass
accuracy. Non-magnetic batteries should be used for the
utmost compass performance.
LRB 6000CI is equipped with battery monitoring sensor.
If display shows “LOW BATTERY” warning when
battery voltage falls below 6.5V this indicates that the
battery is used up. You can still get readings, but the
battery needs to be replaced soon.