NordicTrack A2550 NTL09107.0 - Manual (Page 9)

9
7. Remove the plastic ties from the handrail assem-
bly. If necessary, press the Cage Nuts (33) into
place.
With the help of a second person, hold the
handrail assembly near the Right Upright (78)
and the Left Upright (74). Connect the Upright
Wire (38) to the console wire.
See the inset
drawing. The connectors should slide to-
gether easily and snap into place. If they do
not, turn one connector and try again.
IF THE
CONNECTORS ARE NOT CONNECTED
PROPERLY, THE CONSOLE MAY BE DAM-
AGED WHEN THE POWER IS TURNED ON.
Remove the wire tie from the Upright Wire (38).
Set the handrail assembly on the Uprights (74,
78).
Be careful not to pinch the wires. 78
74
Console
Wire
Wire Tie
7
8. Attach the handrail assembly to the Uprights
(74, 78) with six 5/16" x 1 1/4" Bolts (7) and six
5/16" Star Washers (10) as shown.
Start all six
Bolts before tightening them.
See assembly steps 4 and 6. Firmly tighten
the 3/8" x 4 1/2" Bolts (6).
7
10
74
Handrail
Assembly
8
9. With the help of a second person, hold the con-
sole assembly near the handrail assembly.
Connect the two wires from the console assem-
bly to the two wires from the handrail assembly.
See the inset drawing in step 7. The connec-
tors should slide together easily and snap
into place. If they do not, turn one connector
and try again.
IF THE CONNECTORS ARE
NOT CONNECTED PROPERLY, THE CON-
SOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON.
Handrail
Assembly
Console
Assembly
9
38
Console
Wire
Handrail
Assembly
38
78 7
7
7
10
10
10
Wires
Wires
Plastic
Tie
Plastic
Tie
33
33