Navini Networks RIPWAVE 40-00460-00R - Manual (Page 8)

Navini Networks, Inc. PMX User’s Guide
Installing Your
PMX The following instructions explain how to install the PMX and its
driver software on your computer. Please read all instructions
before attempting the installation.
NOTE: The laptop should be used preferably on a desk when the PMX
is installed. Using the laptop with the PMX close to the body, such as
on the lap, is undesirable.
NOTE: The screenshots shown in these instructions were taken from a
laptop operating with Windows 2000. If you have a Windows XP
operating system, the screens you see may vary from the screens shown
in the instructions.
Step Action
Illustration
1. Insert the PMX into the
Type II card slot on your
laptop. Be sure to insert
the end that has the 68-
pin connector into the
card slot.
2. Raise the antenna to the
upright position.
3. The Found New
Hardware box appears
indicating the PC sees
the PMX.
Windows 2000 Screen
4. The Welcome to the
Found New Hardware
Wizard dialog box
appears. Click Next to
continue. Windows 2000 Screen
Page 8
060825_pv1.3_pmx_user_guide_40-00460-00Ra(4.5)